lap joint
英 [læp dʒɔɪnt]
美 [læp dʒɔɪnt]
（互）搭接（头）；叠接；搭接接头；搭接缝; 搭接接头；搭接焊缝
英英释义
noun
- joint made by overlapping two ends and joining them together
双语例句
- This paper is to discuss the interlaminar stresses of adhesive lap joint by the energy method without considering the adhesive layer.
本文以能量法求解无胶层厚度的搭接接头的层间应力。 - Test shows that this way can exhibit good result to butt joint and lap joint of TIG welding and accurately abstract welding seam out, to the welding seam of large magnitude dogleg angle shows good tracking effect ( dogleg angle< 68 °) and procession speed< 100 ms.
实验表明，系统对TIG焊的对接和搭接焊缝有很好地处理效果，对大幅度折线焊缝也能很好的跟踪（折线角>68°），处理速度>100ms。 - The orthogonal test of numerical modeling on the peck stress distributed in single lap joint
单搭接接头峰值应力数值模拟的正交法分析 - Based on the principle and process of laser transmission welding, the lap joint form was taken and the key technology and difficulty of welding were also considered.
基于激光透射焊接的原理和过程，采取搭接接头形式进行焊接，同时焊接关键技术和难点也被考虑。 - We can obtain the good appearance and defect-free brass and aluminum alloy lap joint when selecting the appropriate parameters.
焊接时选取合适的工艺参数，可以获得外观形貌良好且无缺陷的异种材料焊接接头。 - The lap joint produces bending effect under the action of tensile load and the bending degree decreases with the increase of yield limit of base material.
搭接接头在拉伸载荷作用下会产生折弯效应，折弯程度随被钎焊母材屈服极限的增加而减小。 - The elasto-plastic finite element method ( FEM) was used to investigate the effect of the elastic modulus of adhesive on the stress and strain distribution in adhesively bonded aluminium single lap joint.
利用弹塑性有限元法研究胶粘剂的弹性模量对单搭接接头应力应变分布的影响。 - Using boundary element method, the interfacial streeses of adhensive lap joint with either perfect or imperfect interface are studied.
采用边界元法计算分析了具有理想界面和非理想界面的双板条胶合搭接连接的界面应力。 - Influence of Elastic Modulus of Adhesive on the Stress and Strain Distribution in Aluminium Single Lap Joint
胶粘剂弹性模量对铝合金单搭接接头应力应变分布的影响 - Most scholars mainly adopted one dimension variation analysis model, and took qualitative analysis on the butt joint, lap joint of the parts in the research field of assembly sequence optimization which targets was dimension quality.
以装配尺寸质量为目标的装配顺序优化研究方面，多数学者主要采用一维的偏差分析模型，对零件间的对接、搭接等接头形式进行定性分析。